shopping cart empty

Sub-ohm possibility ??
Login to post a new topic and to write a reply.
Thread Tools Rate This Thread

Search within thread:

Login to rate this thread.
#11 (permalink)      5/4/2014 7:20:39 AM US Central   quote/reply + tips
  • JoinedJun 2013
  • Posts 5644
  • Reviews 269
  • Kudos5410
exactly the same build with a thinner wire.

the fasttech kick i have works with 1.2 ohms

you will be disappointed with the 12 watt maximum output of this if a sub ohmer
Green Screwdriver for LIFE
#12 (permalink)      5/4/2014 7:26:42 AM US Central   quote/reply + tips
  • JoinedDec 2013
  • Posts 10521
  • Reviews 307
  • Kudos8088
I am still prefering the VV kick. Gives a much smoother vape (120? Hz vs 33hz). The buzzing is annoying too sometimes.
#13 (permalink)      5/4/2014 7:43:29 AM US Central   quote/reply + tips
  • JoinedJul 2013
  • Posts 904
  • Reviews 343
  • Kudos543
With these kicks, I stay above 1.2 ohms (that seems to be the lowest load they can drive) and am happy with their performance in driving atomisers at around 1.6 ohms. They also work fine with clearos, even above 1.8 ohms...

Other than my 0.7ohm Taifun GT, I only "sub-ohm" (not agressively - I don't like washed-out taste of some overcooked ejuices) on my stay-at-home kit, which is mostly genesis-type, and drippers.

I prefer mesh wicks, use some silica, and minimise my use of cotton. My kicks are usually used in combination with 18350 cells,when I am out. At home, my 3D (not a great atomiser, but so convenient to load up ...) gets most dripper use currently, and is set up as a dual coil device, using lightweight coils, at 1.6ohms, driven by one of these kicks...
Initially, it was a 1.8ohms single coil (I will probably go back to a single-coil setup on it,tbh)

One normally runs multi-coil setups "natural", but I've found that one can use a kick on lightweight dual-coils almost anywhere and still benefit from the constant vape a kick can provide...

This kick works fine with the mini-protank 3 atomiser's 1.5ohm dual-coils , too...
#14 (permalink)      11/1/2016 12:02:31 PM US Central   quote/reply + tips
  • JoinedFeb 2015
  • Posts 28
  • Reviews 56
  • Kudos9
I have been using a 1.22 ohm coil (8 turns 27 awg kenthal 2.5 mm) in my EK V2 with this kick for 1 1/2 years and it's still working good