shopping cart empty
WORLDWIDE FREE SHIPPING

Latest "Improvements" For Me Wicking
Login to post a new topic and to write a reply.
Thread Tools Rate This Thread


Search within thread:

Login to rate this thread.
#31 (permalink)      7/28/2015 2:52:00 AM US Central   quote/reply + tips
Michelarm
Member
  • JoinedApr 2014
  • Posts 3312
  • Reviews 4
  • Kudos731
Puff_Cabby wrote:

Ok, best results tonight


2.5mm coil

6-8 wraps 24awg, can't remember tbh, you'll get between 5-8 ohms anyway

10mm wide Muji or Original cotton strips, pull top and bottom layers off

Twist one end so it goes through for pulling

Pull through and trim so the ends just overhang the deck

Wet and form into half moon sitting on deck

Chimney on, spread cotton and make channel over the channels

Fit and fill,

Mines 0.8 @ 30w, 35w is also behaving on both 70/30 and 50/50 juice.


I use more in da coil lesson da deck workz best for me. What mod do u got? .
Peace

#32 (permalink)      7/28/2015 5:06:31 AM US Central   quote/reply + tips
Avatar
Puff_Cabby
Member
  • JoinedMay 2014
  • Posts 7453
  • Reviews 48
  • Kudos3894
Sigelei 150w and a Kbox,

It's all working now Mich no dry hits anymore.
#33 (permalink)      9/23/2015 1:39:58 PM US Central   quote/reply + tips
Avatar
Puff_Cabby
Member
  • JoinedMay 2014
  • Posts 7453
  • Reviews 48
  • Kudos3894
This is my current bestie set up, no leaks and no dry hits YET!


10mm strip

Take off the top and bottom layers

Roll it but avoid twisting it

Insert it and cut the tails to just sit on or above the deck and channels

Wet it and push back to form the cotton triangle each side

Using a syringe needle or similar make a horizontal full width indent at the bottom of the cotton tail so you effectively create a cavern of juice under the cotton.