Product Reviews
WORLDWIDE FREE SHIPPING


Sort:
brushy
Verified

VERIFIED OWNER
  • JoinedApr 2017
  • Posts 15
  • Reviews 20
  • Kudos18
Overall   (4.7)
› Quality
› Value
PROS
- Clean appearance - Lots of extras - Metal and ultem tank section (spare tanks) - Simple to build - True MTL experience (can go tighter than a cigarette) - 22mm meaning it'll fit most mods
CONS
- Leaks after refilling - Slightly difficult to wick - 2ml juice capacity - Tight o-rings on top cap
Although this tank isn't my only MTL out there, it definitely provides the tightest airflow of any other tank I've tried. This is THE reason to go for a berserker mini.

The berserker only allows you to dial in a single airflow hole, with the largest being a slightly loose draw, going down to an extremely restricted draw. The tight draw remindes me of a similar draw to when I rolled my own and used thin filters. The larger hole is reminiscent of using the extra large filters.

This kit comes with a heap of extras, that being two drip tips and three different tank sections. The extras get a warm welcome from me since I know how irritating it can be to wait for a new glass section to arrive once you need to replace it. The metal glass section remindes me of the kayfun prime section, however the ultem section looks amazing paired toghether with the ultem drip tip.

The form factor of the berserker is great too as it's 22mm size allows me to put this onto some of my older mods. This will fit almost any modern mod out on the market with no issues at all. The tank also isn't tall so it doesn't look out of place on a 22mm regulated stick mod.

I mentioned the kayfun prime earlier in this review, and I have to say that the build deck on this one is 100% a clone of the kayfun prime. Do I see this as a bad thing? No because that build deck is simple to work with. It's a simple case of dropping your coils under the screws, tigthening and snipping off the leads. My issues however came with wicking. After many dry hits on this atty, I decided that I'd try to wick this like the Vandy Vape Kylin (cutting the wicks so they're long enough to fill in about 50% - 70% of the juice well). To my surprise, this has worked flawlessly for me and I haven't had any more dry hits since then, or any random leaking.

The refill cap however is atrocious. After filling up my tank, I partially screw down my topcap (which has unnecessarily tight o-rings on it), flip the tank upside down and continue tightening the topcap. This has 100% of the time flooded my deck and un-flooding it each time is a hassle.

Overall, this isn't a bad tank but I wouldn't recommend this for a beginner. I believe that this is geared for a builder who has a decent amount of experience with RTA's and understands how to wick them efficiently. The desk being flooded on every re-fill definitely is a big let down and I more often find myself reaching from my Digiflavor Siren 2 more often since refilling that tank doesn't have this issue at all (and the smallest hole on that is about the same size as the second smallest hole on the berserker).
Reviewed on
VeeRay
Verified

VERIFIED OWNER
  • JoinedJun 2018
  • Posts 70
  • Reviews 135
  • Kudos28
Overall   (5.0)
› Quality
› Value
PROS
- taste is great with proper build - build quality is very good - looks great - zero dry hits so far - tight draw = superb taste with proper build/power
CONS
- the screws cannot grab the 28/26ga...which are THE wires for MTL. Needs old school trapping, which needs a bit of practice. - it has a learning curve otherwise it won't taste as good or will taste quite odd, but after that... - needs the topcap and juice port little oring removed, they contribute nothing, just a nuisance that goes away, machining is so good topcap closes without them. - meh driptips
This is an atty that needs patience, but it's worth it.
The kayfun-esque build deck will do the job and exceed expectations if you space the coils, raise 1.5 mm above airflow, use mid afc hole or lower,use normal 28/26 Ni80 (or SS if you must, but too hot) and fill but don't over stuff the juice wells. But do make sure it's evenly filled with cotton or it will seep, like any bottom airflow tank. Say no to any fancy wire, use normal round one, 2.5mm ID, 7-10 wraps spaced, and it's just amazing.

However

In their infinite wisdom, VV has made the top of the screws a bit too small - and this is my only con, really - so you need to wrap the coil leg 180/360 deg around each screw.

So instead of doing the build in 2 minutes .....well, practice makes perfect.

Airflow is very smooth. The drip tips are good but tend to catch some condensation depending on the temp.
I have 2, will buy again. ( will not buy the v1.5)
Reviewed on
Lorentsen
Verified

VERIFIED OWNER
  • JoinedJun 2017
  • Posts 2
  • Reviews 62
  • Kudos0
Overall   (5.0)
› Quality
› Value
The Vandy Vape Berserker Mini is one of the best MTL RTAs out there, competing with higher end tanks. Easy to build on, good flavor, very quiet and perfect machining. You'd be hard pressed to find a better MT tank, highly recommend.
Reviewed on
Avatar
MajorT0M
Verified

VERIFIED OWNER
  • JoinedJul 2017
  • Posts 48
  • Reviews 116
  • Kudos13
Overall   (4.7)
› Quality
› Value
PROS
great quality flavour price
CONS
none
Once you get the wicking right this is an amazing mouth to lung RTA, the quality is excellent.
i use mine every day and it has replaced the siren and the siren 2 as my prefered mtl.

Reviewed on
VeeRay
Verified

VERIFIED OWNER
  • JoinedJun 2018
  • Posts 70
  • Reviews 135
  • Kudos28
Overall   (5.0)
› Quality
› Value
PROS
-Tight -Taste is awesome
CONS
- some may need a bit of time to learn it
Out of production now. If you have an opportunity to buy it, buy it of you like a tight draw cause this one is. Also tasty.
Reviewed on
VeeRay
Verified

VERIFIED OWNER
  • JoinedJun 2018
  • Posts 70
  • Reviews 135
  • Kudos28
Overall   (5.0)
› Quality
› Value
PROS
-taste -taste -tight airflow.
CONS
- not all are born equally, some draw air
Out of production now but i'd recommend one if you stumble upon such occasion
Taste on par/better with top players for anything not NET
Leaks if under wicked, but only then.
i adore mine
Reviewed on
Samsik
Verified

VERIFIED OWNER
  • JoinedJun 2017
  • Posts 2
  • Reviews 3
  • Kudos0
Overall   (4.7)
› Quality
› Value
PROS
All
CONS
Non
This RTA is just perfect! One of the best flavors that MTL RTA can do.
Reviewed on
Alex6969
Verified

VERIFIED OWNER
  • JoinedMay 2017
  • Posts 6
  • Reviews 89
  • Kudos0
Overall   (5.0)
› Quality
› Value
PROS
PERFEKT
CONS
keine
Perfekt für MTL, einfach zu verlegen und super Geschmack und die Qualität ist super.

absolute Kaufempfehlung. TOP
Reviewed on
masood1
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 21
  • Reviews 119
  • Kudos3
Overall   (5.0)
› Quality
› Value
King of mtl
Near near kayfun prime
Loving it
Reviewed on
likvidator
Verified

VERIFIED OWNER
  • JoinedJun 2016
  • Posts 1
  • Reviews 27
  • Kudos0
Overall   (5.0)
› Quality
› Value
PROS
Nice little rta. Easy to build.
CONS
Nothing
Nice little rta. Easy to build.
Reviewed on