TCM56's Product Reviews
Sort:

Avatar
TCM56
Verified

VERIFIED OWNER
  • JoinedOct 2013
  • Posts 834
  • Reviews 45
  • Kudos508
Overall   (5.0)
› Quality
› Value
PROS
These are good quality
CONS
None
If you're in need of a good tiny 1.5mm Phillips type screw driver, then you get a good one in this. For the price don't pass it up if you work on small things.
Reviewed on

Avatar
TCM56
Verified

VERIFIED OWNER
  • JoinedOct 2013
  • Posts 834
  • Reviews 45
  • Kudos508
Overall   (4.5)
› Quality
› Value
PROS
They do what they are suppose to they stay stuck on
CONS
3 separate pieces
If you have vamo's and want to protect the finish or have one scratched up and want to cover it up, or you just want a change of pace in the look department, then these will serve the purpose. They stick on and stay stuck. But the one thing I wish they were, is one solid piece instead of three separate pieces. Trying to have to match the graphics up while applying them with the three separate pieces can be a challenge to get correct to make it look like one solid piece wrapped around.
Reviewed on

Avatar
TCM56
Verified

VERIFIED OWNER
  • JoinedOct 2013
  • Posts 834
  • Reviews 45
  • Kudos508
Overall   (3.7)
› Quality
› Value
PROS
Nice looks
CONS
Had an issue with the positive bloke the pos pin is not adjustable juice channels too narrow
This RBA has been advertised and or claimed all over the internet as a possible 'kayfun killer". No it's not even close. It builds like the kayfun but the vape quality in taste and cloud production falls hort. This may be due to the very narrow juice channels. So if you're handy with a dremal tool, it's advised to open them up. My Ruzgar had a major issue. The chamber, though screwed onto the RBA when I received it, had a major problem. It touched the pos block of the deck causing a short. I had to get my tools out and shave down the positive block on the base and the wire capture screw as well, so it would not short out. Once I got past that obstacle the build was easy. There is little room on this rba so be careful as you also can cause a short with the chimney top cap once you screw it on. I had to give this a higher rating in build quality then I wanted to in order get my review to post But I rate the one I received at about a 3 in build quality.
Reviewed on

Avatar
TCM56
Verified

VERIFIED OWNER
  • JoinedOct 2013
  • Posts 834
  • Reviews 45
  • Kudos508
Overall   (3.7)
› Quality
› Value
PROS
Pretty well built A good intermediate to advanced RBA
CONS
Polishing of the parts didn't match spinning center post
Can read my complete review here @ https://www.fasttech.com/forums/1767700/t/1325337/my-first-impression-first-of-a-couple-builds
Reviewed on

Avatar
TCM56
Verified

VERIFIED OWNER
  • JoinedOct 2013
  • Posts 834
  • Reviews 45
  • Kudos508
Overall   (5.0)
› Quality
› Value
PROS
Well made Makes a kayfun look nice.
What can you say in a review about colored replacement tanks! Well they are built well, fit both the kayfun 3.1 and lite. Like most plastic and polycarbonate tanks, there is some e-juice that you don't want to use with these. Their acidic value plays havoc with the materials. I like them so well, I have reordered a second set for those just in case times.
Reviewed on